ArmorWall structural insulated sheathing (SIS)
It takes the commercial wall and completely rethinks this installation by adding a structural element to the exterior face of the fused insulation layer. This innovation allows the designer to again use tried and true methods of the past, making wall construction efficient, speedy, and code compliant while solving the challenge of continuous insulation.
a non-coated panel and requires a field-applied weather-resistant membrane prior to installation of exterior wall finish. Field application allows greater flexibility in choice of membranes which have been tested for compatibility and performance.
arrives complete with a vapor-permeable weather resistive barrier coating. Once seam and fasteners have been sealed the envelope may be considered “dried-in” allowing interior construction to commence regardless of final exterior finish status.
has an applied non-permeable weather resistive barrier coating. Once seam and fasteners have been sealed the envelope may be considered “dried-in” allowing interior construction to commence regardless of final exterior finish status.
MaxLife’s technology fuses a cementitious element to the exterior face of our fused insulation layer. The insulated Portland-cement board, is designed to be installed over a traditional weather-resistant barrier and gypsum sheathing wall framing assembly and to accept direct adhered masonry, EIFS, and stucco applications all while allowing a continuity between differing exterior finish materials and differing ArmorWall panels to which they are applied.
is a below-grade factory waterproofed exterior wall sheathing with a UL Classified substrate that is a tested high strength fire resistant exterior insulated wall sheathing product that is designed to assist in insulating the slab edge and below-grade to above-grade transition that is often difficult to construct in the field. Combining the best traits of Magnesium Oxide (MgO) and urethane insulation allows ArmorWall to be unmatched within the marketplace.
-Water control layer
-Air control layer
-Thermal Control Layer
-NFPA 285 Approved